I originally started developing with the LPC2368 beta unit on a Windows XP machine. All was working fine with the Windows serial port driver. When the new (current) driver was released, I started using that and it wored fine. I then added a Vista machine to my office. I then loaded the new drivers onto the Vista machine and all worked fine.
Recently, I received my LPC1768 mbed. I tried it on my Vista machine, and had to re-install the Windows serial port driver but all is working well on it. Now, either board works fine on this machine.
Virtual Serial Port Driver 10.0 Build 10.0.858Updated on May, 12th 2021Official Website: https://www.eltima.com/products/vspdxp/. Virtual Serial Port Driver Registration Code - ninefasr.
I then tried to run the LPC1768 on my XP machine, and again found I had to re-load the Windows Serial Port Driver. When I did, Windows reported that there was a problem and could not start the serial port driver. I tried re-installing it several times, both from the website as well as from a local drive copy. Finally, I went back to my LPC2368 mbed. Re-installed drivers, and everything works fine. Going back to the LPC1768, it fails. It always says the driver could not start. I have uninstalled, re-installed, etc., but to no avail.
Again, everything works fine on my Vista machine, just not on my XP machine, and only with the LPC1768 board...the LPC2368 works fine.
Any clues as to what might be the issue?
Thanks.
Virtual Serial Port Driver Xp
Jim
